E-mail: sales@china-oilseals.com
Tel.: +86 139 3371 7202
E-mail: sales@china-oilseals.com
Tel.: +86 139 3371 7202
If you suspect that you have a bad valve seal, there are a few steps you can take to try to repair it:
valve seals
Use a small brush or toothbrush to clean any dirt or debris from the valve and the area around it.
Spray or apply a penetrating oil, such as WD-40, to the valve stem and the surrounding area. This can help to loosen any stuck or seized parts and make it easier to remove the valve.
Use a valve removal tool, such as a valve spring compressor, to remove the valve from the engine. Be careful not to damage the valve or the valve seat while removing it.
Once the valve is removed, inspect the seal for any visible damage or wear. If the seal is damaged, it will need to be replaced.
Use a seal replacement tool to remove the old seal and install a new one. Make sure the new seal is properly seated and aligned before reassembling the engine.
Carefully reassemble the engine, making sure to tighten all bolts and screws to the proper torque specifications.
If you are not confident in your ability to perform these repairs, it is recommended that you seek the help of a professional mechanic.
